How to repair sliding jaw on Jeep J20

That is wired the wrong way around hence why you are lifting the lever to engage the spindle clockwise and more importantly the oil pump that circulates the oil around the headstock will not work.

Felicitaciones por su creativa artesania

Как сделать дома за пару часов очень даже не плохо!

Great job! I can see these being used on bolts where you don't want to scratch the finish (i.e. anodized aluminum)

You just can’t do without clamps and having sufficient number to do the job. I decided a couple years ago to invest in the Bessey and over that time purchased 16 of various sizes...never looked back. Definitely a worthwhile investment.

Erramienta echa en casa

Молодец!

Beautifull, i like it.

travail magnéfique,mais il faut donner les dimention et l'épaisseur du fer plat et la cornière,merci

Very good system

My only question is why did you use both alen and slotted screws and why wouldn't you weld instead of bolting down?

is gooooooooood

Есть и за бугром рукастые ребята. МОЛОДЕЦ!!! Могу подсказать как сверлить круглые детали небольшого диаметра - привариваешь пластину квадратную к большому патрону. Зажимаешь кругляк в патрон ставишь на стол сверлильного станка и сверли на здоровье. Я себе такой сделал, главное угол 90 градусов между патроном и пластиной.

Its cool buddy

If you didn't have a welder you could tap that piece of angle iron instead.

Nice job

you could sell those

Oh, a beautiful wooden wrench

useful material, good workmanship, the result is very good

Woodglut has very good designs and plans.

Video advice: if you film something, but don't use the audio (purely for example) like the part where you punched marks 0:58, don't bother recording the audio in the first place. You'll find that a decent chunk of the footage is going to be audio (depending on how it's recorded). So disable audio (most modern cameras, if not all, have that option) and save yourself transfer time, HDD space, editing time, hassles with encoding and so on.

Please make corner clamp for car case

I clicked on this to see a host of other clamps other than just one high end clamp and one low end clamp. You did not give much information except the Bessy. What about Bora or other parallel clamps. Sorry this was not a good side by side comparison.

I was an apprentice moulder maker at DS&G From 1975-1979 working on lathe beds with two of the best teachers an apprentice could have. Percy Calvert and Frank Haigh.

boa noite isso ai levou no mínimo um mês pra fazer

... тут рекламы.

uses his wooden vise to make a metal vise... cant stop technological progress!