How to repair ignition control module on Saturn L300

Saka video po paano mag ayos sa kumalas na hand brake cable

How do I know if it's oil sending unit or oil pressure valve. I have terrible amount of oil all under my engine. But oil dip stick shows good.

Nilinis mo sana ung bellhousing

Gud am oo mr.yabe ask ko lang po bakit malakas ang presure sa tagas sa valv cover ko bgo na po ... gasket sa valv cover pero tumatagas parin lakas ng presure yhundai starex po sakin.slamat po

Wahhh mnatp lurrr Semoga bermanfaat bagi viewer nya

Hati2 kerjanya

Sir yabe. may video po ba kau sa tune up para starex.slamat

What throttle cable bracket are you using

Yes Like 3 ok you

Makasih bos tutorialnya, mantab

Thank you so much! I just drove home with the oil light on, Had oil in it, recently changed seemed to be getting oil to the rockers.. Watched your Video, traced the wire and there was a bad contact! wohoo!!

NICE VIDEO

2017, Ram 1500, cam sensor, and both cam phasers on both sides, done under warranty luckily, at 38,000 miles. I hope this motor lasts, Is this typical???

or should I say plan B?

Ano kayang diperensya pag bumaba ... menor pagkatapos palitan ... timing saka balancer belt?

Semangat L300 aku jg ada l300.bisa dpt ilmu bisa pasang terot.sndiri..makasi h bos nambah pngalaman,ga yutub bisa bermanfaat bagi orang lain.dan banyak subcreb

Sir bakit may talsik na langis sa deep stick ko.dati wala naman ...,GLS S Mitsubishi adventure akin unit di ko muna pina biyahe.ano kaya dapat gawin?salamat in. Advance po

Hadir ku menjadikan gelap dan jempol yg menancap

What size socket and wrench is used to remove the Phaiser? Thank You

Ipag patuloy mo lang ... pag share ng knowledge mo sir. Sending my support from MoisesAutoAndTrucksS ervices☝️✅

Boss ano pala size ng graese pum

Hadir pertama kasih pin ya

Boss san location mo

Sir tanung poh may vedio kaba sa top overhaul ng 4d56. Pasend nga sir

camshaft sensors and camshaft adjusters related?? Because I was told my camshaft sensors need to be replace and camshaft adjusters.

Bermanfaat kawan, tambah ilmu

Is it possible to have leak in oil pressure switch? because my oil pressure switch is always soaking wet.

yo how did you mount the carb? my original jug was angled to fit the carb, but now its to angled down.

Bro where did you buy that for £80 Looks very good price and also do you really have to take the battery wires off???

Was doing my 3.6L and the 12 links count is wrong, its eduardoserrano170

I could literally listen to your voice all day, every day for the rest of my life... Amazing vids as well, any chance you could start making a few more miniature models like this one or the mushroom lights?